|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
2 - 6 GHz Cascadable GaAs MMIC Amplifier Technical Data MGA-64135 Features * Cascadable 50 Gain Block * Broadband Performance: 2-6 GHz 12.0 dB Typical Gain 0.8 dB Gain Flatness 12.0 dBm P1 dB * Single Supply Bias * Cost Effective Ceramic Microstrip Package applications include narrow and broadband IF and RF amplifiers for commercial, industrial, and military requirements. This MMIC is a cascade of two stages, each utilizing shunt feedback to establish a broadband impedance match. The source of each stage is AC grounded to allow biasing from a single positive power supply. The interstage blocking capacitor as well as a resistive "self-bias" network are included on chip. The die is fabricated using HP's nominal .5 micron recessed Schottky-barrier-gate, gold metallization and silicon nitride passivation to achieve excellent performance, uniformity, and reliability. 35 Micro-X Package Description The MGA-64135 is a high performance gallium arsenide Monolithic Microwave Integrated Circuit (MMIC) housed in a cost effective, microstrip package. This device is designed for use as a general purpose 50 ohm gain block in the 2 to 6 GHz frequency range. Typical Typical Biasing Configuration Vd RFC 4 3 IN 1 MGA C block OUT 2 5965-9005E 6-192 MGA-64135 Absolute Maximum Ratings Symbol Vd Pdiss Pin Tch TSTG Parameter Device Voltage Total Power Dissipation[2] CW RF Input Power Channel Temperature Storage Temperature[3] Units V mW dBm C C Absolute Maximum[1] 12 650 +13 175 -65 to 175 Thermal Resistance: Liquid Crystal Measurement: jc = 150C/W [4]; TCH = 150C 1 m Spot Size [5] Notes: 1. Operation of this device above any one of these parameters may cause permanent damage. 2. Derate linearly at 8.3 mW/C for TCASE > 103C. 3. Storage above +150C may tarnish the leads of this package making it difficult to solder into a circuit. After a device has been soldered into a circuit, it may be safely stored up to 175C. 4. The thermal resistance value is based on measurements taken with the device soldered to a 25 mil Teflon PCB. 5. The small spot size of this technique results in a higher, though more accurate determination of jc than do alternate methods. See MEASUREMENTS section for more information. MGA-64135 Electrical Specifications, TA = 25C Symbol GP GP -- VSWR P1 dB NF -- Id Parameters and Test Conditions: Vd = 10 V, ZO = 50 Power Gain (|S21| 2) Gain Flatness Gain Variation vs. Temperature TCASE = -25C to +85C Input VSWR Output VSWR Output Power at 1 dB Gain Compression 50 Noise Figure Reverse Isolation (|S21| 2) Device Current f = 2 to 6 GHz f = 2 to 6 GHz f = 2 to 6 GHz f = 2 to 6 GHz f = 2 to 6 GHz f = 2 to 6 GHz f = 2 to 6 GHz f = 2 to 6 GHz Units dB dB dB Min. 10.0 Typ. 12.0 1.20 0.5 1.5:1 1.4:1 Max. 2.0:1 2.0:1 dBm dB dB mA 10.0 12.0 7.5 35 35 50 65 6-193 MGA-64135 Typical Performance, TA = 25C 16 15 9.0 14 GP (dB) 12 13 NOISE FIGURE (dB) 0 2.0 4.0 6.0 8.0 14 8.5 P1 dB (dBm) 8.0 10 12 8 6 0 2.0 4.0 6.0 8.0 10.0 FREQUENCY (GHz) 11 FREQUENCY (GHz) 7.5 7.0 2.0 4.0 6.0 8.0 FREQUENCY (GHz) Figure 1. Power Gain vs. Frequency, Vd = 10 V. Figure 2. Output Power @ 1 dB Gain Compression vs. Frequency, Vd = 10 V. Figure 3. Noise Figure vs. Frequency, Vd = 10 V. 2.0:1 1.8:1 VSWR 1.6:1 INPUT 1.4:1 OUTPUT 1.2:1 1.0:1 0 2.0 4.0 6.0 8.0 10.0 FREQUENCY (GHz) Figure 4. VSWR vs. Frequency, Vd = 10 V. MGA-64135 Typical Scattering Parameters (ZO = 50 , TA = 25C, Vd = 10 V) Freq. GHz S11 Mag Ang dB S21 Mag Ang dB S12 Mag Ang Mag S22 Ang 0.5 1.0 2.0 3.0 4.0 5.0 6.0 7.0 8.0 9.0 10.0 .27 .18 .14 .17 .20 .18 .07 .15 .23 .32 .43 -38 -44 -67 -91 -105 -114 -162 96 76 63 52 10.6 12.9 14.3 14.5 14.2 13.6 12.8 11.8 10.8 9.5 8.6 3.38 4.42 5.21 5.33 5.11 4.79 4.35 3.89 3.46 2.98 2.68 174 -9 -54 -93 -131 -167 157 123 92 63 38 -31.0 -33.1 -34.9 -37.1 -37.8 -37.3 -38.5 -36.0 -34.3 -29.3 -27.6 .028 .022 .018 .014 .013 .014 .012 .016 .019 .034 .041 -13 -20 -19 -21 -15 -10 -1 3 4 12 -11 .38 .26 .16 .11 .11 .14 .17 .16 .10 .04 .09 -41 -48 -59 -75 -71 -57 -41 -42 -54 159 116 6-194 35 Micro-X Package Dimensions .085 2.15 4 GROUND .083 DIA. 2.11 1 641 RF INPUT RF OUTPUT 3 .020 .508 2 GROUND Notes: (unless otherwise specified) 1. Dimensions are in mm 2. Tolerances in .xxx = 0.005 mm .xx = 0.13 .057 .010 1.45 .25 .100 2.54 .022 .56 .455 .030 11.54 .75 .006 .002 .15 .05 6-195 |
Price & Availability of MGA-64135 |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |